In males with delayed puberty: Various dosage regimens have been used; some call for lower dosages initially with gradual increases as puberty progresses, with or without a decrease to maintenance levels. Other regimens call for higher dosage to induce pubertal changes and lower dosage for maintenance after puberty. The chronological and skeletal ages must be taken into consideration, both in determining the initial dose and in adjusting the dose. Dosage is within the range of 50 to 200 mg every 2 to 4 weeks for a limited duration, for example, 4 to 6 months. X-rays should be taken at appropriate intervals to determine the amount of bone maturation and skeletal development (see INDICATIONS AND USAGE and WARNINGS ).
First things first. Sterility. Only use new pins and do not share, do not let the pins make contact with anything that may be hazardous by keeping the plastic covering on when not being used, use substances which you are sure are legit, reputable, and are sterile, wash hands thoroughly before any procedures, inject in a clean sterile environment, and make sure the injection site is cleaned with antibacterial agents before and after administration. It’s easy to just skip this paragraph or become lazy over time, thinking that you will be fine. If you want to reduce your risk of infections (which can be very painful and put you out of training for a while), then always think about sterility before and after administration. Be smart.