The Prop Protector cut the rope cleanly, and all the netting. It didn’t shred the netting but cut through it, dividing it in two, and would prevent your boat being anchored by a long length. When the polytarp was left to drift into the prop, it tended to get caught on the blades and just swirled around, but as soon as a slight amount of tension was applied, it was cut through. However, it wasn’t shredded and sometimes remained on the blades, which would reduce thrust. In practice, a large sheet would possibly apply enough drag to make the cutter work. It couldn’t cut any of the wires, though. The netting and smaller diameter ropes could sometimes be drawn down into the gap between the cutter and the P-bracket but reversing tended to loosen this.
Tyres fail if they have serious cuts, bulges or other damage.
The wear on the tyre is checked with a tyre tread depth gauge to ensure compliance.
The tyres are examined to ensure that there is no fouling with any part of the vehicle, unless part of the steering mechanism design.
1. Although under-inflation is not in itself a reason for failure (on vehicles on which the TPMS test is applicable, if a fault is indicated by the TPMS then that will be a fail), a brake test may be inadvisable because of possible damage, and it may affect headlamp alignment. The condition of the spare tyre is not part of the MOT.
2. From 2012, Tyre Pressure Monitoring Systems (TPMS) will form part of the MOT Test. Vehicles on which TPMS was originally fitted will have to have it fully operable. When this test is implemented one faulty sensor will result in a fail.